1400 Bridge - Validating Throughput

Unanswered Question
Apr 29th, 2008
User Badges:


Excuse the newbie question, but I am trying to validate the throughput between a pair of Aironet 1410's. Would using the command:

dot11 dot11radio 0 linktest rate 54 packet-size 1400 count 1500 target <mac address of other end of bridge>

Work for determining throughput, or is that only validating that the packet is transmitted at 54Mbps? If this doesn't tell me throughput, is there a generally accepted method of determining throughput across a bridge?



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Scott Fella Tue, 04/29/2008 - 09:56
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

You can use a tool called iperf or use Qcheck to test for throughput.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode