04-29-2008 10:02 AM - edited 03-03-2019 09:44 PM
our 2811 gets the internet from comcast static IP and communicates to other devices to our network via a T1.
I need to setup a port forward to allow traffic to a webcam insode the network, anything coming from outside (comcast)on port 80 and send it to 10.10.xxx.xxx
Not sure how to do this.
need helpd.
thank you.
Zeek
Solved! Go to Solution.
04-29-2008 11:04 AM
ip nat inside source tcp 10.10.xxx.xxx 80
Don't forget to allow it on your ACL too.
Hope that helps.
04-29-2008 11:04 AM
ip nat inside source tcp 10.10.xxx.xxx 80
Don't forget to allow it on your ACL too.
Hope that helps.
04-29-2008 11:08 AM
when i get to IP nat inside source ... i have to pick one of these:
list Specify access list describing local addresses
route-map Specify route-map
static Specify static local->global mapping
which one should i chooose?
04-29-2008 11:58 AM
Done fixed.
Thank you
04-29-2008 12:02 PM
Sorry, I was going off the top of my head :-)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide