Busy Tone after Max Connections

francois.staiesse · ‎04-30-2008

I configured the "max-conn" parameter on my H323 voice gateway (see "dial-peer" here below).

When the maximum number of calls is reached, the calling party receives the "out of order" tone.

Is it possile to configure something so he would receive the "busy" tone in that case in place of that "out of order" tone?

!

dial-peer voice 26 voip

description 9611 To CCM Publisher

preference 1

max-conn 20

answer-address .

destination-pattern 9611

progress_ind setup enable 1

translate-outgoing calling 1

modem passthrough nse codec g711alaw

voice-class codec 10

voice-class h323 1

session target ipv4:172.16.251.5

dtmf-relay h245-alphanumeric

fax rate disable

no vad

!

Thanks in advance if you can help me.

ebreniz · ‎05-06-2008

It's a matter of how "max-conn" works. We need to limit the maximum number of calls to a DID. When we use "max-conn" to do so the outside caller is not receiving a busy signal but a message stating to check the number and dial again.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080087edb.html