04-30-2008 05:48 AM - edited 03-10-2019 03:49 PM
Can you setup a remote agent to be used by more then one ACS. I have two ACS servers V4.1 and I would like to have two remote agents and have either ACS access both remote agents.
During the remote agent install it request one IP of a ACS.
thanks
Steve
05-07-2008 12:19 AM
Yes, this should be possible. After initial setup you can add additional ACS servers in the CSAgent.ini file.
Add the additional ACS servers to the PermitedClients option
More details can be found at http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_and_configuration_guide_chapter09186a0080193a9b.html#wp838093
Joost
03-21-2010 08:55 PM
ConfigProviderHost=192.168.1.x ,192.168.2.x
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: