ASA Acitve/Standby after failover

Answered Question
May 1st, 2008

ASA 5520 failing over just fine. My issue is that I want the primary ASA to become acitve after its back on line. I cant find any commands that bring the Primary unit back up to acitve after it fails, I know I can get it back manually, but it really needs to be dynamic. Thanks for your help.

I have this problem too.
0 votes
Correct Answer by JORGE RODRIGUEZ about 8 years 7 months ago

Jake,

You have to configure failover group Preemption to accomplish such behaviour.

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/failover.html#wp1002608

HTH

Rgds

Jorge

Rate any helpful post

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.

Actions

This Discussion