cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
365
Views
0
Helpful
1
Replies

ASA Acitve/Standby after failover

cjake7777
Level 1
Level 1

ASA 5520 failing over just fine. My issue is that I want the primary ASA to become acitve after its back on line. I cant find any commands that bring the Primary unit back up to acitve after it fails, I know I can get it back manually, but it really needs to be dynamic. Thanks for your help.

1 Accepted Solution

Accepted Solutions

JORGE RODRIGUEZ
Level 10
Level 10

Jake,

You have to configure failover group Preemption to accomplish such behaviour.

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/failover.html#wp1002608

HTH

Rgds

Jorge

Rate any helpful post

Jorge Rodriguez

View solution in original post

1 Reply 1

JORGE RODRIGUEZ
Level 10
Level 10

Jake,

You have to configure failover group Preemption to accomplish such behaviour.

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/failover.html#wp1002608

HTH

Rgds

Jorge

Rate any helpful post

Jorge Rodriguez
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: