Restrict User Access

Answered Question
May 1st, 2008

I have successfully setup remote access where my remote users can connect and authenticate against Active Directory. I have a single pool of IP addresses that the ASA5510 hands out to the remote users. Everything works great. I now have a request from a vendor that needs remote access for support issues. I need to control this access to only allow access to a single IP address within the internal network. I don't see how to control this. Do I need to create a dynamic acl and apply it to the vendors username or is there a more simple process?

Thanks in advance for any help,

Ken

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
tohoken Fri, 05/02/2008 - 10:49

Thank you. That is what I needed. In all my searching I could not find a document that provided this information

Actions

This Discussion