Combine flash memory

Answered Question
May 2nd, 2008

Anyone who can help me find the command to combine my 2x32mb flash to have a single 64MB flash memory so I could upload an IOS larger than 32MB?

Thanks!

I have this problem too.
0 votes
Correct Answer by Paolo Bevilacqua about 8 years 6 months ago

You're welcome, please rate useful posts with the scrollbox below.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Pravin Phadte Fri, 05/02/2008 - 06:32

Hi,

I am not sure how format would help. As i went through a cisco documnet which says partition can work for integrating 2 flash.

Partitions Flash memory.

Router(config)# partition flash partitions [size1 size2]

Partitions Flash memory on the Cisco 1600 and 3600 series.

Router(config)# partition flash-filesystem: [number-of-partitions] [partition-size]

http://www.cisco.com/en/US/docs/ios/12_2/configfun/configuration/guide/fcf009_ps1835_TSD_Products_Configuration_Guide_Chapter.html#wp1001191

let us know if it helps.

cisco_lad2004 Fri, 05/02/2008 - 06:39

U are absolutely correct, it is partition and not format.

It has been a long time since I used it on my 2500. and it definitely works as it shouls.

apologies for the hasty reply !

Sam

mbserrano Sun, 05/04/2008 - 18:41

Hello Guys, im not sure if i got you there. here's my problem: I have an on board flash which is 32MB and i have a compact flash at 32MB also. i want to install an IOS which is around 36MB so i need flash size of more than 32MB. how can i combine the two 32MBs so i could have a single 64MB?, well if it is possible.

Thanks,

MArlon

Actions

This Discussion