05-02-2008 12:13 AM - edited 03-09-2019 08:38 PM
Hi
i am using ASA5510 for my network.i have configured static and Dynamic NAT.static NAt working fine.Dynamic NAT pool have a 10 public Ip Addresses.but inside users cannot able to access internet.
Error:
Port map Translation failed.
but this dynamic NAT changed to PAT .its working.
Please help me to configure Dynamic NAT
regs
S.Mohana sundaram
05-02-2008 06:25 PM
can you post your nat and global commands that you have configured please. is the dynamic nat pool in the same network range as the IP address of your outside interface of the ASA?
05-02-2008 06:56 PM
Hi
yes.my global pool same as outside Ip range
my puplic ip is x.x.x.0/27
the above subnet have 30 Ip's active the range is x.x.x.1 to x.x.x.30,x.x.x.31 is broadcast.
global (outside) 1 x.x.x.15-x.x.x.29
nat (inside) 1 172.16.0.0 255.255.0.0
static (DMZ,outside) x.x.x.4 10.1.1.2 netmask 255.255.255.255
static (DMZ,outside) x.x.x.5 10.1.1.3 netmask 255.255.255.255
static (DMZ,outside) x.x.x.6 10.1.1.4 netmask 255.255.255.255
static (DMZ,outside) x.x.x.7 10.1.1.5 netmask 255.255.255.255
static (DMZ,outside) x.x.x.8 10.1.1.6 netmask 255.255.255.255
Thanks.
regs
S.Mohana sundaram
05-05-2008 05:16 AM
with this configuration, what is the output of "show xlate".
also, have you tried something like:
global (outside) 1 x.x.x.15-x.x.x.28
global (outside) 1 x.x.x.29
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: