Hello:
I am trying to configura a ringdown on a FXO port, configuration seems to be fine, when i pickup my phone it gives me a message "Your call cannot be completed"
Here is my debug VPM signal,
May 2 13:36:40.209: htsp_timer_stop3 htsp_setup_req
May 2 13:36:40.213: htsp_process_event: [0/3/1, FXOLS_ONHOOK, E_HTSP_SETUP_REQ]fxols_onhook_setup
May 2 13:36:40.213: [0/3/1] set signal state = 0xC timestamp = 0
May 2 13:36:40.213: htsp_timer - 500 msec
May 2 13:36:40.465: htsp_process_event: [0/3/1, FXOLS_WAIT_DIAL_TONE, E_DSP_SIG_1100]fxols_power_denial_proc
May 2 13:36:40.465: htsp_timer2 - 1000 msec
May 2 13:36:40.465: htsp_timer_stop
May 2 13:36:41.465: htsp_process_event: [0/3/1, FXOLS_WAIT_DIAL_TONE, E_HTSP_EVENT_TIMER2]fxols_timer2_proc
May 2 13:36:41.465: htsp_timer_stop
May 2 13:36:41.465: htsp_timer_stop2
May 2 13:36:41.465: [0/3/1] set signal state = 0x4 timestamp = 0
May 2 13:36:41.469: htsp_process_event: [0/3/1, FXOLS_ONHOOK, E_HTSP_RELEASE_REQ]fxols_onhook_release
I see there is an FXOLS_WAIT_DIAL_TONE, message. Is that mean it is expectiong a dial-tone from the telco?
Thanks
