DFM Alerts

Unanswered Question
May 2nd, 2008

Is there any way to get alerts to clear by themselves instead of manually clearing alerts. I.E I have set Utilization thresholds alert which is working fine but they don't clear by themselves once they are below threshold.Is they any way to to do this or am I missing something?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Joe Clarke Fri, 05/02/2008 - 08:32

This should happen automatically. Please post the event details of a Utilization event which has not cleared, but should.

dionjiles Fri, 05/02/2008 - 08:48

You are correct. Looks like I was confused once again. How about the reachability alerts have some still with a status of active from a week ago.

Joe Clarke Fri, 05/02/2008 - 08:52

DFM needs to be able to ping (ICMP) all managed IP addresses on a device, and query the interface by which a device was added using SNMP. Make sure those things can happen.


This Discussion