Maintenance image version FWSM ?

Unanswered Question
May 2nd, 2008

HI,

How to check the Maintenance image version in a FWSM? DO I have to login in the boot mode?

I am going to upgrade the FWSM but looks like I have to upgrade the Maintenance image first.

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
JORGE RODRIGUEZ Fri, 05/02/2008 - 13:30

Refer to Checking the Maintenance Software section in this link

http://www.cisco.com/en/US/docs/security/fwsm/fwsm31/upgrade/guide/fwsm31up.html

Step 2 ..To boot the FWSM into the maintenance partition, enter the command for your operating system at the switch prompt:

•For Cisco IOS, enter the following command:

Router# hw-module module mod_num reset cf:1

•For Catalyst operating system software, enter the following command:

Console> (enable) reset mod_num cf:1

Actions

This Discussion