Andrew,

Thanks for the links. I have found that vpn guide just a day or 2 ago, and it looks relatively straight forward. I do have one question though.... and that is that all the access lists that I've seen for allowing traffic to/from is all set up for static IP addresses. I have a wic-1enet plugged into a dsl modem in bridge mode, so I had to copy a Dialer 1 Int config from someone else's post and my IP is not static. How would I change the access lists for traffic flow in my situation?

Thank you,

Mark

If I could rate myself, I would, but I can't. I at least want to have the post with an answered check mark so others with the same question can at least find the information I did to help them out.

Once again, I've had to answer my own post, but for others that may read on...I'll attach some links and documents that helped me.

http://tools.cisco.com/search/display?url=http%3A%2F%2Fwww.cisco.com%2Fen%2FUS%2Fdocs%2Fios%2F12_2t%2F12_2t8%2Ffeature%2Fguide%2Fftunity.html&pos=1&strqueryid=1&websessionid=aICDl3l3s5aTaJM4hmuuZag

http://tools.cisco.com/search/display?url=http%3A%2F%2Fwww.cisco.com%2Fen%2FUS%2Fdocs%2Fios%2F12_4%2Fsecure%2Fconfiguration%2Fguide%2Fhunity.html&pos=2&strqueryid=1&websessionid=aICDl3l3s5aTaJM4hmuuZag

http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6635/ps6659/prod_white_paper0900aecd80313bf8.pdf

http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6635/ps6659/prod_white_paper0900aecd80313bf2.pdf