05-04-2008 12:25 PM - edited 03-15-2019 10:26 AM
My CCME often has one or two DN get hung. No tones come out of the phone. I tried to remove the DN but got the message: 'DN 2 has active call on interface 50/0/2 CH1.Cannot unconfigure'. My only solution is to reload the CCME. Do you have any better ways to kill the active DN?
IOS version: c2801-advipservicesk9-mz.124-11.XJ4.bin.
Thanks in advance.
Solved! Go to Solution.
05-04-2008 03:17 PM
I believe it's an issue with phone FW.
Go on CCO CME area, locate and download CME124-4XC4.ZIP.
From there, extract P0030070T023.tar, and upgrade the 7940 with this firmware.
It's the only FW that never presented the problem in my case.
Hope this helps, please rate post if it does!
05-04-2008 12:52 PM
Which phone model is that and which exact FW on it ?
05-04-2008 12:57 PM
Hi Paulo,
Every time this happens to the 7940G phones. I am using load 7960-7940 P00307020400.
Thanks.
05-04-2008 03:17 PM
I believe it's an issue with phone FW.
Go on CCO CME area, locate and download CME124-4XC4.ZIP.
From there, extract P0030070T023.tar, and upgrade the 7940 with this firmware.
It's the only FW that never presented the problem in my case.
Hope this helps, please rate post if it does!
05-04-2008 03:21 PM
Thanks Paulo,
I will try and get back to you later.
Rgd.
05-14-2008 07:18 PM
10 days passed and this problem has not come back again. This seems fixed the problem.
Thanks.
05-14-2008 11:26 PM
Glad to know it helped. Thanks for the nice rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: