Inventory and configuration for some models is failed

Unanswered Question
May 5th, 2008
User Badges:

The fetch configuration and inventory is failed for below devices:


1-Cisco Catalyst 2948G-L2 Switch with WS-C2948 Software, Version NmpSW: 4.5(3), System Bootstrap Version: 5.4(1)


2-Cisco Catalyst 4003 Switch with WS-C4003 Software, Version NmpSW: 4.4(1),System Bootstrap Version: 4.4(1)


We have CiscoWorks LMS 2.6 RME 4.0.5 with type NON-ACS and AAA Mode Setup: TACACS+


After troubleshooting the problem, when I telnet the device, I can access it as user privilege only then enable password by local enable password

When I changed device Credentials of enable password in DCR, I can fetch configuration but still the inventory can't be fetched.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
David Stanford Mon, 05/05/2008 - 07:59
User Badges:
  • Cisco Employee,

Is there an error you are getting on inventory colletion? We will collect the inventory via snmp.

oalvi Mon, 05/05/2008 - 21:50
User Badges:

No, just failed to collect invetory

Actions

This Discussion