05-05-2008 09:22 AM - edited 03-15-2019 10:27 AM
HI all,
recently i tried to configure an ISDN connection with CallManager and it works fine but i'm stuck in something and thanks for ur previous posts by the way
I have a range of number from my SP like:
from 555501 to 555509 and i want that a predefined IP Phones like extension 4000 to use a specific PSTN number for inbound and outband Call and with an anology from the FXO conf i set up the:
Destination-pattern 9T for outband call
and
Connection plar opx 4000 for the inband
BUT with the BRI how it can be done?
Thanks in advance for all
05-05-2008 08:46 PM
You can configure the BRI either as MGCP or H323
If H323 then configure a dial-peer pots with direct inward dial then a voip to fwd the number directly to ccm
If MGCP Just configure proper CSS and incoming settings for Voice Port
05-05-2008 10:50 PM
thanks for your reply but if the user want to use a specific number as his personnel PSTN number i mean for example if DN 4000 want only to use the PSTN number 555022 as the outband call ?
05-06-2008 12:25 AM
Hi is anyone there :) and thanks again for ur post Sir.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: