Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
237
Views
0
Helpful
1
Replies

Route for 2 provider

Go to solution
sun_sazanov
Level 1
Level 1

‎05-05-2008 09:56 AM - edited ‎03-05-2019 10:46 PM

Hi. I have gw2821 and 2 internet provider. Lan 10.10.10.0/24.

As to me make for IP 10.10.10.0-10.10.10.100 use 1 provider, and ip 10.10.10.101-10.10.10.254 use another provider?

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Thotsaphon Lueangwattanaphong
Level 7
Level 7

‎05-05-2008 11:34 AM

Hi Slava,

Seems you guys need to use PBR functions and correct NAT commands on each interfaces.

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&topicID=.ee71a06&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dded2da

Just modify the configuration I provided to beat your requirement.

Hopes this helps

Thot

View solution in original post

0 Helpful
1 Reply 1

Go to solution
Thotsaphon Lueangwattanaphong
Level 7
Level 7

‎05-05-2008 11:34 AM

Hi Slava,

Seems you guys need to use PBR functions and correct NAT commands on each interfaces.

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=WAN%2C%20Routing%20and%20Switching&topicID=.ee71a06&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dded2da

Just modify the configuration I provided to beat your requirement.

Hopes this helps

Thot

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card