Mobility Manager Configuration Guide for CUCM 6.X

Unanswered Question
May 5th, 2008
User Badges:


Can someone please point me in the right direction.

I am looking for the configuration guide for Mobility Manager for CUCM6

I am having issues when calling into voice access from the mobile phone, authenicating OK, then pressing "1" to dial an extension number. The call clears down as soon as the # is entered after the extension number.

Can someone please help



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
shingphing_2 Mon, 02/09/2009 - 01:34
User Badges:


Did you managed to resolve as I have the same problems


steve-parrish Mon, 02/09/2009 - 01:39
User Badges:


check your CSS on the Remote Destination

also make sure your codec's negotiated ok

shingphing_2 Mon, 02/09/2009 - 01:52
User Badges:


I did not configure any css and connect works fine.


steve-parrish Mon, 02/09/2009 - 01:55
User Badges:

I found MVA uses the CSS on the RD to allow calls through option "1", (not the reroute CSS)

shingphing_2 Mon, 02/09/2009 - 01:59
User Badges:

thks .but all my css and partition are set to "none".do you thk these will affect the option "1" routing.I have no problem calling out from phones.Call options 1 call internal extension?

steve-parrish Mon, 02/09/2009 - 02:04
User Badges:

Try using DNA with the RD Extension number and ensure you can make all necessary call types

shingphing_2 Mon, 02/09/2009 - 02:13
User Badges:

thks .In fact i have a ip communicator with the RD extension which have no problems making outside calls.

Have a pleasant day !!


This Discussion