voice gateway configuration issue

Answered Question
May 5th, 2008
User Badges:

Hi,


I'm using a CCM 4.1 and a Cisco 2801 (adv ip services) with PVDM-64 and VWIC-2MFT-E1.

When i try to configure pri-group timeslots using the commands : pri-group timeslots 1-31 service mgcp I have the following error message :

%Insufficient resources to create pri-group - it has been removed


Could please see for me what could be the problem ?

P.S : the 2801 router is not a bundle voice, i have just added the PVDM card.

Correct Answer by Rob Huffman about 8 years 10 months ago

Hi Dominique,


I have seen this in a few instances where the VWIC is installed in slot 0 instead of slot 1. (only WIC modules are supported in slot 0.


Hope this helps!

Rob


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
Rob Huffman Mon, 05/05/2008 - 17:10
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Dominique,


I have seen this in a few instances where the VWIC is installed in slot 0 instead of slot 1. (only WIC modules are supported in slot 0.


Hope this helps!

Rob


dom.a Mon, 05/05/2008 - 17:16
User Badges:

Ok, but i think it is not the case for me. See the attached file for the 'sh diag' command response. it indicates that PVDM2-64 is installed on PVDM slot 1.


have a look on this attachment pls.



Jaime Valencia Mon, 05/05/2008 - 17:32
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

Rob never mentioned the PVDM2 module on the wrong slot, but the VWIC in slot 0 when it should be in slot 1.


see what you have:


VIC Slot 0:

E1 (2 port) Multi-Flex Trunk WAN daughter card


HTH


javalenc


if this helps, please rate

dom.a Mon, 05/05/2008 - 17:45
User Badges:

ok ok , excuse me. So I need to replace the VWIC card on slot 1 instead of slot 0.


Let me try it...


Thanks Rob & Javalenc.

Rob Huffman Mon, 05/05/2008 - 17:40
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Dominique,


I think this clip shows the issue;


VIC Slot 0:

E1 (2 port) Multi-Flex Trunk WAN daughter card

Hardware revision 1.0 Board revision D0

Serial number 34010819 Part number 800-04479-03

FRU Part Number VWIC-2MFT-E1=



It does show a VWIC in VIC Slot 0 which is not supported on a 2801. Can you try moving the VWIC-2MFT-E1.


Hope this helps!

Rob

Actions

This Discussion