Bad Design?

Unanswered Question
May 6th, 2008
User Badges:

Im looking over a design of a remote site, and I am a little confused



The interface on router for the lan is 192.168.96.6


However, the cat switch that is connected

to that interface has an IP address of

192.168.97.6 (vlan1) learned via dhcp


router#GigabitEthernet0/1 is up, line protocol is up

Internet address is 192.168.96.251/23




router#sh cdp neighbors gigabitEthernet 0/1 det

-------------------------

Device ID: LAN1

Entry address(es):

IP address: 192.168.97.6


How can you have 2 interfaces connected

on different networks?


And the users all getting 192.168.97.x

ip's while the router they are connecting

to has 192.168.96.x on the interface?



and here is the config for the cat switch


interface Vlan1

ip address dhcp

no ip route-cache


ip default-gateway 2x6.xx.xx.209

ip http server

access-list 25 permit 192.168.0.0 0.0.255.255




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Tue, 05/06/2008 - 06:05
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

Because the network has a /23 subnet mask so the two addresses are on the same network ie.


192.168.96.0 255.255.254.0 covers the range


192.168.96.1 -> 192.168.97.254


Jon

Actions

This Discussion