Hi Guys,
I have a problem with a Cisco Aironet 1242AG. I have attempted to reset the unit to factory default. As per Cisco manual guides.
I am using a straight through cable with db9 serial to rj45 adapter. The specs are : using com1, bps 9600, data bits 8, Parity none, stop bits 1, Flow control (here I have tried none and Xon/Xoff)
Would any one have suggestions why the ethernet interface would be down.
In attempting to isolate ip address the wireless unit has given me a reply that its DNS ip
is 255.255.255.255
It did give some commands such as "ether_ineted"
to renable it but this has not had a resolution to a unit which is being difficult to configure.
The wireless unit indicator light signal shows green. I should also add the ethernet cable terminates in the console port.
Thanks in advance,
Regards
Murali