snmp traps will not stop

Unanswered Question
May 6th, 2008

We are getting a ton of snmp "cold start" traps. About every minute or less. I even took the statement out of the configuration to stop the device from sending those traps but they're still coming.

I used the "no snmp-server traps enable snmp coldstart warmstart"

I verified that it was no longer in the config as well. Any help?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
MZydorczyk2 Mon, 06/23/2008 - 08:52

These are coming from our wireless access points. We dont want to turn off all status traps on them either.

Scott Fella Mon, 06/23/2008 - 13:46

Are your ap's bouncing? I have only seen this when the ap is on the secondary controller and fails to joins its primary.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode