05-06-2008 08:32 AM - edited 03-09-2019 08:39 PM
Dear sir
I m unable to see show isdn status command for PRI on my 2801 and 3745 router.I have tried
c2801-ipvoicek9-mz.124-15.T4 and c2801-spservicesk9-mz.124-11.T with 2801.
Kindly help me out
Solved! Go to Solution.
05-06-2008 11:29 AM
I'm guessing you don't have the pri-groups defined in your config.
Not an IOS issue but a configuration issue.
05-06-2008 08:43 AM
could you put the relevant show run output and show controller t1.
Were these once working T1's or are they newly installed?
05-06-2008 08:45 AM
could you put the relevant show run output and show controller t1.
Were these once working T1's or are they newly installed?
05-06-2008 09:41 AM
rosalza
actually these are newly installed PRI.
I have using vwic-2MFT.g703 and and Vwic-2MFT-E1.
my controller is
controller e1 0/0/0 and controller e1/0/0/1
could u plz clear me is it a IOS issue or something else
05-06-2008 11:29 AM
I'm guessing you don't have the pri-groups defined in your config.
Not an IOS issue but a configuration issue.
05-06-2008 11:57 AM
thanks rozalaza
i was missing pri-g
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: