Configure Trunk

Answered Question
May 6th, 2008

Our Customer had a one CallManager in Genebra and another in Brazil, I am try configure the trunk, but, the call not complete. The protocol used is MGCP. The range extension in Brazil is 1XXX at 6XXX, and Genebra 9XXX. When I do debug isdb q931 in CallManager Brazil appear the message "Cause i = 0x829c - invalid number format (incomplete number). The principle the configuration Trunk it's Ok, but, I don't know tell if configuration route pattern, route list this is OK. In this moment I have access the all equipment in the IP solution.


Thank You,


Wilson


Thank You

Correct Answer by kolkatagtc about 8 years 9 months ago

Hi Wilson, Just try to do the following configs in each of the CCM Server's.


Brazil :

1. Create a RP of 9xxx and select the ICT created as the gateway. If there are multiple servers then there will be multiple ICT's created. In that case create a RL with all the ICT's and select that ICT in the RP.


Do just the opposite RP's in Genebra. Those will be 1xxx & 6xxx.


Rate the solution if this works.


Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Jaime Valencia Tue, 05/06/2008 - 10:34

is the incoming CSS on the GW able to reach the phones??


HTH


javalenc


if this helps, please rate

wilsonsant Wed, 05/07/2008 - 04:30

Hi Javalenc,


I believe that yes, but, who I can me certificate?


Thank

Correct Answer
kolkatagtc Wed, 05/07/2008 - 01:43

Hi Wilson, Just try to do the following configs in each of the CCM Server's.


Brazil :

1. Create a RP of 9xxx and select the ICT created as the gateway. If there are multiple servers then there will be multiple ICT's created. In that case create a RL with all the ICT's and select that ICT in the RP.


Do just the opposite RP's in Genebra. Those will be 1xxx & 6xxx.


Rate the solution if this works.


Thanks.

wilsonsant Wed, 05/07/2008 - 04:16

Hi Kolka,


I am sorry, what is the significate ICT?


Thank You,


Wilson

Actions

This Discussion