SNMP Traps still being received

Unanswered Question
May 7th, 2008
User Badges:

Hi,


Just wondering if anyone has come across a similar issue, basically an Network Management Station is still receiving snmp traps after I have configured each interface to stop sending the snmp traps for the fast/e ports, still want the traps sent for the Gig uplink ports


snmp-server community xxxxxx RO xx

snmp-server ifindex persist

snmp-server trap-source Loopback0

snmp-server enable traps snmp warmstart linkdown linkup coldstart

snmp-server enable traps config

snmp-server enable traps envmon fan shutdown supply temperature status

snmp-server enable traps syslog

snmp-server host 192.1.1.1 xxxxx


Typical Interface would have the following snmp config


interface FastEthernet0/1

no logging event link-status

no snmp trap link-status


I'm beginning to think that the NMS is polling the switches every so often and the alerts it is receiving aren't actually originating from being sent, but the results of the switches being polled as there are some alerts showing up on the NMS that aren't actually in the logs.


Cheers

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
cisco_lad2004 Wed, 05/07/2008 - 03:46
User Badges:
  • Gold, 750 points or more

I was going to say teh exact same thing as ur last comment regarding polling.


how often u get the alarm, if it concide with polling time intervals it must be polls. you can also increase polling time or remove ur community access so device is not polled.


if you are sniffing, ports will be different 162 for traps and 161 for polls.


HTH


Sam

smithsera1 Wed, 05/07/2008 - 04:31
User Badges:

Thanks alot for that Sam,


I'll go ahead and try sniffing the switches and see what comes out of that.


Cheers

Paul

Actions

This Discussion