Console links state alerts not showing

Answered Question
May 7th, 2008

This is probably an easy question.

When i issue a terminal monitor command on a cat 6500, I am not getting info on link state changes.

ex.

%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up

%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to down

I can not see anything using "debug interface ?" that jumps out as the obvious answer. Any ideas?

Thanks.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
cisco_lad2004 Wed, 05/07/2008 - 06:01

do u have snmp trap link-status configured under interface ?

SNMP needs to be activated in some cases, like this one.

HTH

Sam

srue Wed, 05/07/2008 - 06:47

you're welcome..thanks for the points...

Actions

This Discussion