Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
518
Views
0
Helpful
5
Replies

Console links state alerts not showing

Go to solution
sdaniels44
Level 1
Level 1

‎05-07-2008 05:49 AM - edited ‎03-05-2019 10:48 PM

This is probably an easy question.

When i issue a terminal monitor command on a cat 6500, I am not getting info on link state changes.

ex.

%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up

%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to down

I can not see anything using "debug interface ?" that jumps out as the obvious answer. Any ideas?

Thanks.

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions
5 Replies 5

Go to solution
cisco_lad2004
Level 5
Level 5

‎05-07-2008 06:01 AM

do u have snmp trap link-status configured under interface ?

SNMP needs to be activated in some cases, like this one.

HTH

Sam

0 Helpful

Go to solution
sdaniels44
Level 1
Level 1
In response to cisco_lad2004

‎05-07-2008 06:27 AM

This has to be done for each interface?

0 Helpful

Go to solution
sdaniels44
Level 1
Level 1
In response to srue

‎05-07-2008 06:44 AM

That was it. Thanks for your help.

0 Helpful

Go to solution
srue
Level 7
Level 7
In response to sdaniels44

‎05-07-2008 06:47 AM

you're welcome..thanks for the points...

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card