05-07-2008 05:49 AM - edited 03-05-2019 10:48 PM
This is probably an easy question.
When i issue a terminal monitor command on a cat 6500, I am not getting info on link state changes.
ex.
%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up
%LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to down
I can not see anything using "debug interface ?" that jumps out as the obvious answer. Any ideas?
Thanks.
Solved! Go to Solution.
05-07-2008 06:40 AM
05-07-2008 06:01 AM
do u have snmp trap link-status configured under interface ?
SNMP needs to be activated in some cases, like this one.
HTH
Sam
05-07-2008 06:27 AM
This has to be done for each interface?
05-07-2008 06:40 AM
see if this link helps:
http://www.cisco.com/en/US/docs/ios/fundamentals/command/reference/cf_l1.html#wp1025176
05-07-2008 06:44 AM
That was it. Thanks for your help.
05-07-2008 06:47 AM
you're welcome..thanks for the points...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: