qos over two switches

Unanswered Question
May 7th, 2008

Do i need to config both cisco switches to enable qos between the switches? or do i need to config one switch so the other switch will understand it automatic?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
scooter817 Wed, 05/07/2008 - 06:36

That depends.. Generally you would configure QOS/COS on both switches so that they understood what was happening. However, there are times when you may want to configure all traffic on a switch port to be set to a specific COS/QOS value and you could do this on one switch and it would apply to all traffic across that port. There would be very specific reasons for doing this though.

Actions

This Discussion