Switch Port Usage for cli

Answered Question
May 7th, 2008

Is it possible to get switch port usage information using the cli commands?

I have this problem too.
0 votes
Correct Answer by Joe Clarke about 8 years 8 months ago

These reports are not yet available via the CLI. They are looking to be added, however, in a future release.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
Joe Clarke Wed, 05/07/2008 - 19:13

These reports are not yet available via the CLI. They are looking to be added, however, in a future release.

jguemes Thu, 05/08/2008 - 07:47

On 3750's switches there is a show controllers util

phretbored Wed, 01/14/2009 - 17:00

We have 9 3750s in a stack and when I run "show controllers utilization" I get zeros for every interface and the last lines of output are:

Total Ports : 468

Switch Receive Bandwidth Percentage Utilization : 0

Switch Transmit Bandwidth Percentage Utilization : 0

Stack Ring Percentage Utilization : 0

It is strange that I get all zeros...does something else need to be configured?

Actions

This Discussion