05-07-2008 10:32 AM - edited 02-21-2020 02:00 AM
Hi,
The tunnel connects and I am able to grab an IP address from the correct range. However, I am not able to pass traffic between the tunnel (192.168.5.0) and the DMZ interface/network (192.168.4.0).
What piece or pieces am I missing from my configuration?
I have attached the config.
thank you,
G
05-13-2008 11:00 AM
Please check your ACL it might be correction required.
05-13-2008 11:09 AM
dmz nat exemption acl should be
access-list NamPix_DVC_nat0_outbound extended permit 192.168.4.0 255.255.255.0 192.168.5.0 255.255.255.0
Also, I don't think you need this route...
no route NamPix_DVC 192.168.5.0 255.255.255.0 192.168.4.1 1
You also have no group policy cdcvid defined.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: