AP1121G, cannot access after convert to autonomous mode

Unanswered Question
May 7th, 2008

successfully downloaded IOS via tftp server to convert the LWAPP to autonomous mode but I cannot access the AP.

I set my station to and continous pinging to but never response by AP. no luck even power cycle and reset (press mode button for 2 seconds while power cycle). I got 'Device no responding' message when I run IPSU.

Any idea?

Thanks in advance,

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Scott Fella Wed, 05/07/2008 - 17:21

Have you tried to consol into the ap and take a look? Are you sure you successfully converted the AP?

Console in and reboot the ap and look at the logs and see what code the ap is running.


This Discussion