Dial peer configuration for SIP and H323 and callmanager

Unanswered Question
May 7th, 2008
User Badges:
  • Green, 3000 points or more

Ok, I have part of my problems fixed, but I cant figure out the rest.


Cisco IP Phone dials 4100

RP 4100 sends it to an h323 gateway

Dial Peer 100 voice

translation-profile incoming voip

destination-pattern ???

session protocol sipv2

session target ipv4:xx.xx.xx.xx

session transport tcp

incoming called-number ???

codec g711ulaw


What should I put in the question marks? 4... or . or?


Do I care about incoming called number?


Like wise, if the End point coming into the H323 calls into the Router looking for a CallManager phone do I use the same type of dial peer?

example:

Dial Peer 101 Voice

translation-profile incoming voip

destination-pattern .

session protocol ?????

session target ipv4:Callmanager IP?

session transport tcp

incoming called-number .

codec g711ulaw


Where do I tell the Dial Peer to go to CallManager?


Thanks much!!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
gogasca Thu, 05/08/2008 - 21:59
User Badges:
  • Green, 3000 points or more

HI TOm,

Remember that we have different rules depending the call flow

We have 2 call legs in every call

For yhe incoming dial peer we match some rules depending of different factors


http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml

For outgoing dial-peer we use destination-pattern


session target ipv4:Callmanager IP?

session transport tcp

incoming called-number .

codec g711ulaw


Where do I tell the Dial Peer to go to CallManager?

You are correct!

This config is for IPIP GW SIP TO H323?



Tommer Catlin Fri, 05/09/2008 - 08:52
User Badges:
  • Green, 3000 points or more

Thanks much for your help!!!


If the SIP end point is sending me +1415xxxxxxx

And I need to strip the + and add 9 to it, can I not do it with this?

destination-pattern +9T ???


I cant seem to get it to work. (unless my PRI is screwy)


Actions

This Discussion