Back to Back Router for WAN simulation

Unanswered Question
May 7th, 2008

Hi Guys!

I want to setup back to back router for WAN simulation using two cisco routers. As of now, i know the basic on how to set it up. But my question is, how can i limit or change the bandwidth. Like if i want to have 64k connection, or to have 128k connection etc. How can this be done? Does the clock rate command affects the bandwidth? or is there any configuration needed to achive this? Please help coz I want to simulate on how much bandwidth our new application needs. Your help is much appreciated.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)


This Discussion