PIX525 and IE

Answered Question
May 8th, 2008

Hi all,

How can i make PIX525 working through IE, Which program that should be added to PIX525 that make it working through IE?

best regards

thaar

Correct Answer by smahbub about 8 years 9 months ago

To use ASDM, you need to enable the HTTPS server, and allow HTTPS connections to the security appliance. All of these tasks are completed if you use the setup command.The security appliance allows a maximum of 5 concurrent ASDM instances per context, if available, with a maximum of 32 ASDM instances between all contexts. WebVPN and ASDM administration cannot be enabled on the same interface. If you enable WebVPN on an interface, then that interface cannot be used for ASDM.

Uset the below commands for configuring ADSM:

hostname(config)# http source_IP_address mask source_interface

hostname(config)# http server enable

hostname(config)# asdm image disk0:/asdmfile

Refer the following url for more info:

http://www.cisco.com/en/US/docs/security/asa/asa71/configuration/guide/mgaccess.html#wp1047288

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
smahbub Wed, 05/14/2008 - 06:08

To use ASDM, you need to enable the HTTPS server, and allow HTTPS connections to the security appliance. All of these tasks are completed if you use the setup command.The security appliance allows a maximum of 5 concurrent ASDM instances per context, if available, with a maximum of 32 ASDM instances between all contexts. WebVPN and ASDM administration cannot be enabled on the same interface. If you enable WebVPN on an interface, then that interface cannot be used for ASDM.

Uset the below commands for configuring ADSM:

hostname(config)# http source_IP_address mask source_interface

hostname(config)# http server enable

hostname(config)# asdm image disk0:/asdmfile

Refer the following url for more info:

http://www.cisco.com/en/US/docs/security/asa/asa71/configuration/guide/mgaccess.html#wp1047288

Actions

This Discussion