cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
256
Views
0
Helpful
1
Replies

cisco IPM

wasiimcisco
Level 1
Level 1

I have cisco IPM installed with cisco LMS, i have configured the IPM with source and target.

both are cisco routers with IOS C2800NM-ADVIPSERVICESK9-M)

Operation type is IP SAA responder. I have configured the operations duration for one hour.

but after one hour I am not able to see any activity in the chart.

IP phone is located behind the source router and CCM is located behind the destination router. Operation type is

statisics not monitoring. But still no activity, it is showing me the following as shown in the attachement.

Where these reports save on the cisco LMS. How to get the latency and jitter report automatcally. Please help me

The Router IOS version is Version 12.4(9)T5.

The IPM Version is

Server: 2.6

Client: 2.6

collector type i have checked both with monitor and statical.

1 Reply 1

hmacread
Level 1
Level 1

Hi There,

It would be good to check that the ip sla probe has been correctly set up on the source router.

On the command line of the router do a "sh ip sla conf" and "sh ip sla stat"

On some versions you need to add "monitor" I.e. "sh ip sla mon conf" and "sh ip sla mon stat"

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: