05-08-2008 09:25 AM - edited 03-13-2019 05:14 PM
OK - I'm sure this is quite simple, but it is eluding me. I am trying to create a CTI route point and can't figure out how to set the appropriate Calling Search space. My simple addLine request works fine:
<SOAP-ENV:Envelope xmlns:SOAP-ENV="http://schemas.xmlsoap.org/soap/envelope/" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xmlns:xsd="http://www.w3.org/2001/XMLSchema">
<SOAP-ENV:Body>
<axl:addLine xmlns:axl="http://www.cisco.com/AXL/1.0"
xsi:schemaLocation="http://www.cisco.com/AXL/1.0 " sequence="1234">
<newLine>
<pattern>8773162555</pattern>
<usage>Device</usage>
<routePartitionName>InboundACDPartition</routePartitionName>
</newLine>
</axl:addLine>
</SOAP-ENV:Body>
</SOAP-ENV:Envelope>
But any attempt to add CSS to the line fails. Where / how / in which structure is this set?
05-08-2008 10:42 PM
The CSS has a bit of a strange name.. it's shareLineAppearanceCss or if you want to use the name, shareLineAppearanceCssName.
It's an optional field and you'd add it after the routePartitionName in your example.
Hope that helps..
05-12-2008 08:27 AM
Ahhh - intutitive, but not obvious. Thanks!
Unfortunately, I find myself out of the frying pan and into another frying pan. I can create my CTI Routepoints, but no matter what I do, the mediaResourceGroupList and MOH entries come up "
My message looks like this (I am assuming that I will deal with the lines later):
xsi:schemaLocation="http://www.cisco.com/AXL/1.0" sequence="7197">
05-12-2008 07:50 PM
you need to use mediaResourceListName, the other 2 might then be ok too ;-)
05-12-2008 11:35 PM
If you're working against a CCM6, you might want to enable debug traces and download the AXL service logs from the ccm using RTMT.. they actually contain quite some useful information. I've found at times I had no error (or no useful error) returned to me, but looking through the debug traces on the ccm I was able to figure out what is going wrong.
And.. it happens every so often that half a command is executed.. usually when some none essential parameter is incorrect, the command will still pass but everything starting with your wrong parameter will not be taken into account anymore. I do not particularly like this behavior, even think it's outright wrong, but so far I haven't had the motivation to raise a case on such an issue.. I usually fix my command and be on my way.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide