Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
708
Views
0
Helpful
2
Replies

Baseline template command still not compliant after deploy

orsonjoon
Level 1
Level 1

‎05-09-2008 02:56 AM

In the baseline template for in this case a Catalyst 3560 access switch I entered the following command:

+ banner motd ^<NL>************************************************************************<NL>* *<NL>* *<NL>* Warning: Access for authorized personel only! *<NL>* *<NL>* Use by unauthorized persons is prohibited. *<NL>* *<NL>* *<NL>************************************************************************<NL><NL>^

When I deploy this to the switch and check the config in the switch the command is correctly entered by LMS 3.0 in the running and startup config.

When after this I run the same template compliance check, it states "not compliant" and when I check the details of the job it's telling me that this command I just deployed with the tool is not compliant.

I noticed that this is not the only command that fails after a deploy in the same way.

If anyone ran into the same problem, please share your thoughts, thanks.

Labels:
0 Helpful
2 Replies 2

Joe Clarke
Cisco Employee
Cisco Employee

‎05-09-2008 09:06 AM

Try using quotes to delimit the banner instead of ^.

0 Helpful

orsonjoon
Level 1
Level 1
In response to Joe Clarke

‎05-12-2008 10:49 PM

That did it, thank very much!

0 Helpful
Customers Also Viewed These Support Documents