unnumbered interface and network-extension mode

Unanswered Question
May 9th, 2008

I've configured EasyVPN with Dynamic Virtual interfaces and its seems everything works fine if I'm using client mode in EasyVPN client. When I changing mode to network-extension it doesn't honor ip unnumbered configuration on my virtual-template and using always IP from my WAN interface.

See in attachment my corresponding configuration on client.

This doesn't affect PCs behind router but affect router responses comes from WAN even if I request from VPN.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
aghaznavi Thu, 05/15/2008 - 11:21

Better solution is to check that the (sub)interface is not in use before provisioning.


This Discussion