Tunnel Problem

Unanswered Question
May 9th, 2008
User Badges:

Dear all,

I just got a new Cisco 3560PC-S (8 port) whose installed IOS is 12.2(35r)SE2. I am trying to configure GRE tunnel on it using interface tunnel 1 command... But it is not taking it.. other crypto commands are not running as well.... Can anyone suggest the proper IOS to which when I upgrade, I get the required results? Thanks in advance


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Jon Marshall Fri, 05/09/2008 - 04:44
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN


Andrew is correct in that as far as i know the 3560 doesn't support these features. Not because it is a layer 2 switch because it isn't only L2 it can support IP routing etc. so it is a fully L3 capable but still it does not include these features.



This Discussion