fxo config issue

Unanswered Question
May 9th, 2008
User Badges:

I am trying to configure a FXO port on CCME 4.1

Calls are coming in o.k but when I disconnect the call from the Callmanager express side, the other party stays connected.

Also I cannot make outgoing calls, I have pasted the relevant detaills below.


dial-peer voice 9 pots

description - Mobile -

destination-pattern 907.........

port 0/0/0

forward-digits 11

!

voice-port 0/0/0

signal groundStart

cptone GB

connection plar opx 3006

impedance complex2

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (2 ratings)
Loading.
silex Fri, 05/09/2008 - 09:05
User Badges:

thanks for the info but I have read ittried that and still no joy, the main concern is not being able to dial out at all

paolo bevilacqua Fri, 05/09/2008 - 09:54
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

May be the port is stuck due to a call remained up. Reload the router and see if you're able to call out.

silex Fri, 05/09/2008 - 10:17
User Badges:

yes I have done that as well.


when i run a sh voice port summary whilst dialling out, I can see the fxo port go off hook

but then nothing happens i do not get any sound


paolo bevilacqua Fri, 05/09/2008 - 10:29
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Is the line active ? Check with a phone.


Beside, if not active, the routerl will tell you that as "power denial" with "debug vpm signal" and "term mon".

silex Fri, 05/09/2008 - 11:59
User Badges:

I have also tried with an analogue phone and it can make outgoing calls, what I have done is completely wipe the config and just used the bare min config with one phone registered, that has worked fine, so obviously i have some misconfig somewhere, I will add a bit at a time

and see wht happens,

many thanks for your help

Actions

This Discussion