05-11-2008 03:17 PM - edited 03-05-2019 10:53 PM
I am getting the below output while pinging remote IP
distribution-1#
Protocol [ip]:
Target IP address: 172.28.9.254
Repeat count [5]: 1000
Datagram size [100]:
Timeout in seconds [2]:
Extended commands [n]: y
Source address or interface: vlan255
Type of service [0]:
Set DF bit in IP header? [no]: y
Validate reply data? [no]:
Data pattern [0xABCD]:
Loose, Strict, Record, Timestamp, Verbose[none]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 1000, 100-byte ICMP Echos to 172.28.9.254, timeout is 2 seconds:
!.!U!.!.!.!U!.!.!.!U!.!.!U!.!U!.!U!.!U!.!U!.!U!.!.!.!U!.!.!.!.!.!.!.!.
!.!.!.!U!.!U!.!U!.!U!.!U!.!U!.!U!.!.!U!.!U!.!.!.!U!.!.!.!.!U!.!U!.!U!.
!U!.!.!.!U!.!U!.!.!U!.!U!.!.!U!.!U!.!.!U!.!U!.!.!.!U!.!.!U!.!U!.!U!.!U
!.!.!U!.!U!.!.!U!.!U!.!U!.!U!.!U!.!.!U!.!U!.!.!.!.!U!.!.!U!.!U!.!U!.!U
!.!U!.!U!.!U!.!U!.!.!.!.!.!U!.!.!.!.!.!U!.!.!.!.!.!.!U!.!.!.!U!.!.!U!.
!.!U!.!U!.!U!.!.!U!.!.!.!U!.!U!.!.!U!.!U!.!U!.!.!.!U!.!.!.!.!.!.!.!.!U
!.!U!.!.!U!.!U!.!U!.!.!U!.!.!U!.!.!U!.!U!.!U!.!U!.!U!.!.!.!.!U!.!U!.!.
!.!U!.!.!.!U!.!.!.!.!.!U!.!.!U!.!U!.!.!U!.!.!.!.!.!.!.!.!.!U!.!.!.!.!.
!U!.!U!.!.!U!.!U!.!.!.!U!.!U!.!U!.!U!.!.!U!.!U!.!.!.!.!.!.!.!.!U!.!U!.
!.!.!.!.!.!U!.!.!.!U!.!U!.!.!U!.!U!.!U!.!U!.!U!.!U!.!U!.!U!.!.!U!.!.!U
!.!U!.!.!.!U!.!U!.!.!U!.!U!.!.!U!.!U!.!.!.!.!U!.!U!.!.!U!.!.!U!.!U!.!.
!.!U!.!.!U!.!U!.!U!.!U!.!.!.!U!.!U!.!U!.!.!.!U!.!.!.!U!.!.!U!.!.!U!.!U
!.!.!.!.!.!.!U!.!.!.!U!.!.!U!.!U!.!U!.!.!.!U!.!.!.!.!.!.!.!.!.!.!.!.!U
!.!U!.!.!.!.!.!U!.!U!.!U!.!U!.!.!.!U!.!.!U!.!.!.!U!.!.!U!.!U!.!.!U!.!.
!.!U!.!.!U!.!U!.!U!.
Success rate is 50 percent (500/1000), round-trip min/avg/max = 4/6/120 ms
distribution-1#
Please help
05-12-2008 01:28 AM
How are you conected to the remote site ?
05-14-2008 07:36 AM
I am connected to the remote sites by 2 lease lines.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: