How do you enable and configure Wi Fi on a c3825 with HWIC AP

Unanswered Question
May 12th, 2008

Hi - Can somebody tell me the best way to enable and configure the wireless capabilities on a c3825 ? It already has a HWIC AP card and i can see the dot11radio interfaces as admin down. My client already has a seperate LinkSys system and wants to migrate to the c3825 wireless. I cannot find the config guides to do this on CCO.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ebreniz Fri, 05/16/2008 - 07:24

These ISRs are a little different, and there sure are a lot of interfaces on your c3825. But after reviewing, I think I can help you bridge your wireless users on ssid 'cng-trk-e' onto the Ethernet VLAN 192 subnet 192.168.5.0/24 with these following commands. I am going to move the IP address from your Ethernet sub-interface, to a BVI (bridge virtual interface) and

add bridging statement under your radio and Ethernet sub-intfs

Here is the example

enable

config t

int dot11radio0/1/0.192

no cdp enable

no ip virtual-reassembly

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

int gigabitethernet1/0.192

no ip address

no ip nat inside

no ip virtual-reassembly

no cdp enable

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

int BVI 192 ip address 192.168.5.1 255.255.255.0

ip nat inside

ip virtual-reassembly

ip route-cache flow

ip tcp adjust-mss 1452

no snmp trap link-status

exit

bridge 192 protocol ieee

bridge 192 route ip

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode