These ISRs are a little different, and there sure are a lot of interfaces on your c3825. But after reviewing, I think I can help you bridge your wireless users on ssid 'cng-trk-e' onto the Ethernet VLAN 192 subnet 192.168.5.0/24 with these following commands. I am going to move the IP address from your Ethernet sub-interface, to a BVI (bridge virtual interface) and
add bridging statement under your radio and Ethernet sub-intfs
Here is the example
enable
config t
int dot11radio0/1/0.192
no cdp enable
no ip virtual-reassembly
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
int gigabitethernet1/0.192
no ip address
no ip nat inside
no ip virtual-reassembly
no cdp enable
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
int BVI 192 ip address 192.168.5.1 255.255.255.0
ip nat inside
ip virtual-reassembly
ip route-cache flow
ip tcp adjust-mss 1452
no snmp trap link-status
exit
bridge 192 protocol ieee
bridge 192 route ip