cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1542
Views
0
Helpful
4
Replies

"Object not found in device"

PeterJacobsen
Level 1
Level 1

Hi

When I try to add new Controller in the WCS (ver. 4.1.91.0) I get this error:

“Failed to add device to WCS Reason: Object not found in device”

The Controller has been added earlier a then deleted again. When I try to re-add the controller again, I get the above error. It's a WLC2106 I'm trying

Both the WCS and the new Controller works fine, and I have tried to boot them both.

Still get the same error when trying adding.

Anyone know what it could be?

TIA

Peter

1 Accepted Solution

Accepted Solutions

Yes I would do that, or revert your controller to 4.1.185 if this version works well for you...

View solution in original post

4 Replies 4

jeromehenry_2
Level 3
Level 3

Which code is your controller running?

If your new controller code is not 4.1.X, this is a typical effect... WCS and controller should share the same major version...

hth

Jerome

Hi Jerome

The WLC2106 is running version 4.2.112.0.

I also have a WLC-4402 that is running 4.1.185.0.

Do you suggest that I upgrade the WLC-4402 to version 4.2.112.0. and the WCS to version 4.2.81.0.? Then all are running 4.2.x.x

TIA

Peter

Yes I would do that, or revert your controller to 4.1.185 if this version works well for you...

af follow up...

After reinstalling to 4.1.185 I don't have the problem any more.

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: