05-13-2008 07:02 AM
Hi,
While configuring the source router, the ip sla monitor command requires additional commands.
Where can i can find the exact command
Solved! Go to Solution.
05-13-2008 08:59 AM
Yes, SNMPv3 is supported. It would help to see the configuration and show ver from this device.
05-13-2008 07:11 AM
What exactly do you want to do? If you're using IPM, then IPM will do all of the setup for you. All you need is SNMP read-write credentials on the device. The only thing you may want to configure is the IP SLA responder. That command is simply:
ip sla monitor responder
05-13-2008 07:32 AM
Hi,
I am using snmp v3 read and write view on the router and the IP SLA does not see the router as possible source.
Does it support v3 or just v2
05-13-2008 08:59 AM
Yes, SNMPv3 is supported. It would help to see the configuration and show ver from this device.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: