dial peer

Answered Question
May 14th, 2008
User Badges:

Hi,


I have two groups of ANI (calling numbers). "Group A" is 2102xxxx, "group B" is "3100xxxx"


I would like to config "group A" users to make IDD (A to Z) via carrier A


and


I would like to config "group B" users to make IDD (A to Z) via carrier B


two group of users call the same toll free number 8001234.


e.g.

21021234 makes an IDD call, he dials

"8001234 then, 0018861234567" --> carrier A


31001234 makes an IDD call, he dials

"8001234 then, 0018861234567" --> carrier B



I use the "answer-address" to control the incomimg ANI but I fail. any idea how to config the dial peer?


rdgs






  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
paolo bevilacqua Wed, 05/14/2008 - 06:29
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

You can use two techniques: COR or "steering digits"


On the incoming DP with answer-address, configure either a COR, or translation-profile to add special digits in front of number.


On the outgoing, you create two DP. With cor, each one will have the proper cor setting. With steering digits, you modify destination-pattern to match the special digits, and again a translation-profile to strip the digits.


Hope this helps, please rate post if it does!

anitachoi3 Wed, 05/14/2008 - 06:41
User Badges:

Hi,


I try following config but fail. any missing?


rdgs


! R1

dial-peer voice 86601 pots

answer-address 2102.

direct-inward-dial

port 6/0:D

prefix 234

!

dial-peer voice 23401 voip

destination-pattern 234.

session protocol sipv2

session target ipv4:192.168.0.1

dtmf-relay rtp-nte digit-drop h245-signal h245-alphanumeric


!

dial-peer voice 86602 pots

answer-address 3100.

direct-inward-dial

port 6/0:D


!

dial-peer voice 86603 voip

destination-pattern 001.

session protocol sipv2

session target ipv4:172.16.1.1

dtmf-relay rtp-nte digit-drop h245-signal h245-alphanumeric



paolo bevilacqua Wed, 05/14/2008 - 06:43
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

It doesn't work because you need to apply one or the other technique I've suggested above, but your config doesn't.

anitachoi3 Wed, 05/14/2008 - 06:49
User Badges:

hi,


Thanks


How to config "a COR, or translation-profile to add special digits in front of number"


I do not have any idea to config it.


rdgs

Correct Answer
paolo bevilacqua Wed, 05/14/2008 - 07:26
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Actions

This Discussion