05-14-2008 08:15 AM - edited 07-03-2021 03:52 PM
How can i get running-config for SNMP.
Here can i see a examples?
05-16-2008 03:35 AM
Here is an example of how I use it. This is from a 1242, however the output is the same on a 1231. My info is bleeped out with #'s
snmp-server community #########
snmp-server location ##########
snmp-server contact A########
snmp-server chassis-id ##############
snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart
snmp-server enable traps disassociate
snmp-server enable traps deauthenticate
snmp-server enable traps authenticate-fail
snmp-server enable traps rogue-ap
snmp-server enable traps syslog
snmp-server enable traps aaa_server
In the running config it shows up right below the access-list.
Hope this is of some assistance.
Thanks,
Alex Pfeil
05-16-2008 05:46 AM
Thanks!
And OID's for SNMP request?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: