Cisco 857 Error when implementing Firewall

Unanswered Question
May 15th, 2008
User Badges:

Hi, I am in the process of setting up a Cisco 857 (12.4(15)T5), when trying to start the firewall via SDM or SDM Express I get the following error:


"class-map type inspect match-any sdm-cls-insp-traffic


Error detected at this command. Click OK"


Then the firewall config doesn't save, can anyone help me out with this please


Thanks,

Chris

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
spremkumar Fri, 05/16/2008 - 05:58
User Badges:
  • Red, 2250 points or more

Hi Chris


Can you confirm on what feature set you are running out there in your router ?


have you tried configuring any other firewall policy rules in the router ?


is it possible to try this config line via cli and check out if you are getting any error message out of it ?


regds


spremkumar Fri, 05/16/2008 - 06:02
User Badges:
  • Red, 2250 points or more

Hi Chris


Can you confirm on what feature set you are running out there in your router ?


have you tried configuring any other firewall policy rules in the router ?


is it possible to try this config line via cli and check out if you are getting any error message out of it ?


regds


shaw.chris Mon, 05/19/2008 - 02:10
User Badges:

Feature Set: C850-ADVSECURITYK9-M


When in configuration mode via the cli it doesn't even recognise class-map as a command.


Thanks.

Actions

This Discussion