05-15-2008 06:53 AM - edited 03-05-2019 11:00 PM
Hi, I am in the process of setting up a Cisco 857 (12.4(15)T5), when trying to start the firewall via SDM or SDM Express I get the following error:
"class-map type inspect match-any sdm-cls-insp-traffic
Error detected at this command. Click OK"
Then the firewall config doesn't save, can anyone help me out with this please
Thanks,
Chris
05-16-2008 05:58 AM
Hi Chris
Can you confirm on what feature set you are running out there in your router ?
have you tried configuring any other firewall policy rules in the router ?
is it possible to try this config line via cli and check out if you are getting any error message out of it ?
regds
05-16-2008 06:02 AM
Hi Chris
Can you confirm on what feature set you are running out there in your router ?
have you tried configuring any other firewall policy rules in the router ?
is it possible to try this config line via cli and check out if you are getting any error message out of it ?
regds
05-19-2008 02:10 AM
Feature Set: C850-ADVSECURITYK9-M
When in configuration mode via the cli it doesn't even recognise class-map as a command.
Thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: